What Is Dielectric Strength? The Best Polymers for Electrical Insulation
Dielectric strength is the maximum electric field an insulating material can withstand before electrical breakdown. For thin insulation, polyimide film and PFA film are strong candidates. For machined components such as insulating washers, bushes and spacers, unfilled PEEK and PEI are good starting points when the part also needs to stay rigid. PTFE is worth considering where chemical resistance and low electrical loss matter.
What does dielectric strength measure?
During a dielectric strength test, voltage is applied across a specimen until it breaks down and current passes through it. Dividing the breakdown voltage by the specimen’s thickness gives the dielectric strength, commonly expressed in kilovolts per millimetre (kV/mm). For example, if a 2 mm specimen breaks down at 40 kV, its measured dielectric strength is 20 kV/mm under those test conditions. Common test standards include ASTM D149 and IEC 60243-1.
Dielectric strength and dielectric constant answer different questions. Dielectric strength tells you the electric field at which insulation breaks down. Dielectric constant, also called relative permittivity, describes how the material responds to an electric field and affects properties such as capacitance. Both can matter when selecting a polymer for electrical or electronic assemblies.
Which polymer should you choose for an insulating component?
- For thin insulation layers, consider polyimide film where high dielectric strength at a small thickness is a priority. PFA film is a strong candidate where chemical resistance and low dielectric loss also matter.
- For rigid washers, spacers, and standoffs, shortlist unfilled PEEK and PEI. PEEK is particularly useful when the component also needs mechanical strength and chemical resistance. PEI is worth evaluating for rigid electrical components that operate at elevated temperatures.
- For chemically exposed insulators or low-loss applications, consider PTFE. Its chemical resistance and low dielectric loss can be more important to the application than achieving the highest breakdown strength in a film test.
For polymer fasteners, reinforcement also matters. Check the exact grade before substituting a filled polymer for an unfilled one. For example, we see substantially lower electrical resistivity in carbon-fibre-filled PEEK 450CA30 than in unfilled PEEK 450G.
Use our datasheet values (find all our datasheets on this page) to shortlist materials, then verify the finished component in its intended assembly. For an insulating washer or bush, the thinnest section, the air gap between conductors and the distance along the part’s surface all matter. Share your drawing, operating voltage and service conditions when enquiring about custom polymer insulators, spacers or fasteners.
